System Settings

Important

When modifying the parameters on this page, scan “Start Settings” first, then scan the target setting barcode; scan “End Settings” after completion.

Restore Factory Defaults

Warning

Scanning this setting barcode will restore the code reading device to factory default settings. Please confirm that the current configuration has been recorded.

Restore Factory Defaults

Prompt Output

Buzzer prompt

Buzzer prompts include power-on prompts and decoding success prompts.

Enable buzzer

*Disable buzzer

Voice prompt

Prompt sounds include decoding success prompts, WeChat/Alipay voice broadcasts and power-on prompts.

*Enable voice prompts

Disable voice prompts

In particular, after disabling payment barcode voice, you can turn off WeChat and Alipay voice reminders.

Disable payment barcode voice

After the payment barcode voice is disabled, there are two prompt methods for non-payment barcode voice: “Ding Dong” and “Scan code completed, start printing”. Select one of the two to take effect, which can be configured through the following setting barcode.

Enable “Ding Dong” alerts

Enable the “Scan QR code completed, start printing” prompt

Volume settings

Volume level 1	Volume Level 2
Volume level 3	Volume level 4
Volume level 5

Read firmware version

Scan the following setting barcode to output the current firmware version information.

Read firmware version

Update firmware

Update firmware

Operation example

Example	Target	Scan Order
Function example 1	Enable buzzer prompts, disable voice prompts	Start setting -> Enable buzzer -> Disable voice prompts -> End setting
Function example 2	Enter automatic sensing mode	Start setting -> Auto sensing mode -> End setting