Network configuration

Network configuration#

Note

Only applicable to scanners that support Wi-Fi transmission, such as DS2800.

Dynamic IP address configuration#

1. Restore Wi-Fi module default settings#

../../_shared/_images/wireless-wifi/AT2BRESTORE.png

Restore Wi-Fi module default settings#

2. Set dynamic IP mode#

../../_shared/_images/wireless-wifi/AT2BDHCP3D1.png

Set dynamic IP mode#

3. Restart the scanner#

../../_shared/_images/wireless-rf-bt/24POWER23OFF.png

Restart the scanner#

4. Configure transmission method#

After configuring the network parameters, you can continue to configure the following transmission methods as needed:

  1. Transfer data using TCP client

  2. Transfer data using TCP server

  3. Transfer data using MQTT protocol

  4. Transfer data using HTTP protocol

Static IP address configuration#

1. Restore Wi-Fi module default settings#

../../_shared/_images/wireless-wifi/AT2BRESTORE.png

Restore Wi-Fi module default settings#

2. Set static IP mode#

../../_shared/_images/wireless-wifi/AT2BDHCP3D0.png

Set static IP mode#

3. Restart the scanner#

../../_shared/_images/wireless-rf-bt/24POWER23OFF.png

Restart the scanner#

4. Set IP address#

5. Set gateway#

6. Set subnet mask#

7. Configure transmission method#

After configuring the network parameters, you can continue to configure the following transmission methods as needed:

  1. Transfer data using TCP client

  2. Transfer data using TCP server

  3. Transfer data using MQTT protocol

  4. Transfer data using HTTP protocol