Trigger settings

Serial Trigger Mode	I/O Trigger Mode
Continuous Decode Mode	Factory Default: Key Trigger Mode

Batch Reading Mode

Auto sensing mode

Continuous Trigger Mode

Decode Interval

Factory Default: 0ms	500ms
200ms	2000ms
1000ms

Sensor Trigger Mode

Trigger Sensitivity

Factory Default: Medium	Low
High

Sensor Interval

Factory Default: 1000ms	5000ms
2000ms

Sensor Timeout

1000ms	Factory Default: 2000ms
3000ms	5000ms

Batch Reading Mode

Unified Output

Factory Default: Disable

Enable

Serial Trigger Mode

Note

The default start command for serial triggering is start, and the default stop command is stop. Use @SETSSX to set the start trigger command and @SETESX to set the end trigger command, where X is your custom content. For example, if the start command is set to A and the end command is set to B, the generated setting barcodes are @SETSSA and @SETESB respectively.