Engine Character Table

Engine Character Table#

Table of suffixes, suffixes and character values#

Prefix/suffix value table#

The key points confirmed are as follows:

  • Prefix/Suffix Values is set via 4 digits

  • Number 1 is the button category

  • The last 3 digits are decimal character values

  • Detailed value table is located at Table E-1

Among some terminal default parameters, typical default values for suffixes and suffixes include:

  • STX (1002)

  • CR (1013)

  • ETX (1003)

FN1 replacement value table#

Used to set the replacement value for FN1 in EAN-128.

The confirmed rules are as follows:

  • Default value: 7013, which is Enter

Setup steps:

  1. Scan Set FN1 Substitution Value

  2. Find the target key value in the ASCII character table of the current host interface

  3. Enter the corresponding 4-digit value

When setting via host command, first set Key Category to 1, and then set the 3-digit key value.